6
EN
Fix it firmly in such a way that it cannot drop,
slip, slide or otherwise move.
• Attach the unused carbine hook (4) on the
heater chain onto the provided ceiling hook or
ceiling hanging eye.
• Take into account the minimum distances as
shown on figure C.
• Plug the patio heater into a grounded power
outlet. Check beforehand if the voltage rating
matches the device.
• Check that the carabiners close properly and
that the device hangs immovably. It must not be
able to slide, drop, slide or the like! Only operate
the heater when it is in the upright position.
Assembling the remote control (Fig. B)
• Flip the remote control (8) to the backside and
remove the battery cover.
• Insert 2 AAA/ Alkaline type batteries into the
remote control (8) in accordance with the
instructions and polarity of the batteries..
• Change the batteries in the same way depicted
above.
4. OPERATION
Switching on/off (Fig. A, B)
The heater can be turned on and off using the re-
mote control (8) only. Before use, the power switch
(5) on the heater must first be turned on. Without
a remote control, the heater cannot be operated. If
you do not have the remote control in your posses-
sion, please contact Vonroc customer service.
• First turn the switch (5) on the heater to the
‘ON’ position.
• Press the button (9) on the remote control (8) to
turn the heater on.
• To turn the heater off, again press the button (9)
on the remote control (8).
• Press the switch (5) on the heater to the ‘OFF’
position to power off.
Note: Make sure to point the remote control (8) in
the direction of the remote control receiver (10). All
VONROC heaters and their remote controls use the
same frequency, so it is possible to control several
heaters with just one remote.
Adjusting the power level (Fig. A, B)
The heater power can be adjusted in two levels:
• Level 1 - 1000W (50% power) ‘L1’ on display (10)
• Level 2 - 2000W (100% power) ‘L2’ on display (10)
The desired level can be selected using the remote
control. Press the heat level button (14) and after-
wards use the up button (12) to increase the level
and down (11) button to decrease the level.
Using the timer function (Fig. A, B)
The heater is equipped with a timer function, ena-
bling the heater to remain on for a selected amount
of time. The selectable range is between 0 and 24
hours and will be shown on the display (10).
For example, when selecting 3 hours on the timer,
the heater will remain on for 3 hours and then will
automatically turn off.
To use the timer, press the heat level button (13)
and afterwards set the timer using the up button
(12) and down (11) button.
5. MAINTENANCE
Always make sure that the machine is not
connected to the mains electricity when you
carry out any maintenance of the mechanism.
CAUTION: Risk of Electric Shock. DO NOT
open or try to repair the heater yourself.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that
the ventilation openings are free of dust and dirt.
Re-move very persistent dirt using a soft cloth moi-
stened with soapsuds. Do not use any solvents such
as gasoline, alcohol, ammonia, etc. Chemicals such
as these will damage the synthetic components.
• DO NOT use alcohol, gasoline, abrasive pow-
ders, furniture polish or rough brushes to clean
the heater. This may cause damage or deteri-
oration to the surface of the heater.
• DO NOT immerse the heater in water
• Wait until the heater is completely dry before
use.
Delta i konversationen om denna produkt
Här kan du dela vad du tycker om Vonroc PH509AC Terrassvärmare. Om du har en fråga, läs först noggrant igenom manualen. Att begära en manual kan göras genom att använda vårt kontaktformulär.