Bruksanvisning Vonroc PH509AC Terrassvärmare

Bruksanvisning

EN

5

WWW.VONROC.COM

TECHNICAL SPECIFICATIONS

Model No. PH509AC

Voltage 220-240 V~

Frequency 50-60 Hz

Power 2000 W

Power settings 1: 1000W

2: 2000W

Heating element type Carbon fibre lamp

Heating time 3 seconds

Wave length 3.0-1000 microns

Radiant efficiency

90%

Heating distance

2-3m

Heating area

7-9m

Colour temperature 1600 K

Overheat protection Yes

Electronic soft start Yes

Ingress protection class IP44

Protection class Class I

Weight 2.36 kg

DESCRIPTION

The numbers in the text refer to the diagrams on

page 2.

1. Hanging chain

2. Power cable

3. Hanging hook

4. Carbine hook

5. On/off switch

6. Heater

7. Protective grill

8. Remote control

9. Remote control on/off button

10. Receiver for remote control with display

11. Down button

12. Up button

13. Timer button

14. Heat level button

3. ASSEMBLY

This heater should be installed by a

competent person, i.e. a qualified electrician.

Always disconnected the heater from the

electrical supply and allow it to cool before

installation.

Installing the heater (Fig. A, C)

Always mount the device with the supplied

accessories.

Before starting the installation, take the following

into consideration:

• Place the device on a firm, level ceiling surface;

installation of the heater should be on a strong

rigid support (such as strong wooden beams or

metal rails etc).

• The device must be hung so that there is 50

cm of free space between the heater and any

ceiling, tent canvas etc. There must also be

at least 1.80 m between the ground and the

underside of the device. Refer to Fig. C. The

device can never be hung on a hook in the wall

as it could hang at a slant!

• The Hook used to hang the heater must be able

to take a weight 3 or 4 times that of the heater

itself.

• Ensure that the power supply cable is well

mounted and that it does not come into contact

with reflector of the heater or that does not trail

into heated area.

• Do not install the heater on an inflammable

surface.

• If the heater is to be used outside, a weatherp-

roof outlet is highly recommended.

• Before drilling ensure that there are no wires or

water pipes in the area where the heater is to

be installed.

To install the heater, follow these steps:

• The device is supplied with a hanging chain (1)

and two carbine hooks (4). Put a carbine hook

(4) on both ends of the chain (1).

• Mount one side of the chain onto the hanging

hook (3) using the carbine hook (4), as shown

on fig. A.

• Provide an attachment point from which the

device can hang down freely and that is sturdy

enough to hold the heater without any problems.

Betyg

Mer om denna bruksanvisning

Vi förstår att det är trevligt att ha en pappersbruksanvisning för din Vonroc PH509AC Terrassvärmare. Du kan alltid ladda ner bruksanvisningen från vår hemsida och skriva ut den själv. Om du vill ha en originalbruksanvisning rekommenderar vi att du kontaktar Vonroc. De kanske kan tillhandahålla en originalbruksanvisning. Letar du efter bruksanvisningen för din Vonroc PH509AC Terrassvärmare på ett annat språk? Välj ditt föredragna språk på vår hemsida och sök efter modellnumret för att se om vi har det tillgängligt.

Specifikationer

Alla bruksanvisningar för Vonroc Terrassvärmare
Fler bruksanvisningar för Terrassvärmare

Relaterade produkter

Bruksanvisning

Vonroc PH510AC Terrassvärmare

Bruksanvisning

Vonroc PH503AC Terrassvärmare

Bruksanvisning

Vonroc PH502AC Terrassvärmare

Bruksanvisning

Vonroc PH511AC Terrassvärmare

Bruksanvisning

Vonroc PH506AC Terrassvärmare

Bruksanvisning

Vonroc PH513AC Terrassvärmare

Bruksanvisning

Vonroc PH507AC Terrassvärmare

Bruksanvisning

Vonroc PH501AC Terrassvärmare

Relaterade kategorier