Bruksanvisning Sylvania SRCD4400 Stereoanläggning

Bruksanvisning

MEMORY

STOP

ST./MO/

REPEAT

BAND

PRESET

-UP

PLL REMOTE CONTROL

SRCD-4400

Remote Control

Control Locations

,

,,

22. MEMORY Button

23. CD PLAY/PAUSE/PRESET-UP Button

24. CD Skip/Reverse ( ) Button

25. STOP Button

26. FM Stereo/Mono/CD REPEAT Button

27. BAND Button

28. CD Skip/Forward ( ) Button

Install battery

1. Open the battery cover to remove it.

2. Insert two AAA batteries (not included) correctly so that the + and - polarities match the polarity diagrams

inside the battery compartment.

Note:

* About half a year of normal operation can be expected when using the general batteries.

* When the batteries are exhausted, the commander should no longer operate the system. Replace both batteries

with new ones.

* When the commander is not to be use for a long time, remove the batteries to avoid damage caused by battery

leakage and corrosion.

* Avoid keeping the commander in extremely hot or humid locations.

* Between remote controller and remote sensor there should be no obstacle and have to within 30 range.

* The remote controller s operating distance is about 0.2M to 6M away from the remote sensor.

,

,,

22

23

24

25

26

28

27

LISTENING TO THE RADIO

OPERATING INSTRUCTIONS

Set the VOLUME Control to a low

setting.

Press the TUNING-Up Button or

TUNING-DOWN Button to find

the desired station.

1

2

Hints for Better Reception

FM - Make sure that the telescopic FM Rod Antenna is raised and extended to its full length. You may

have to vary the direction of the antenna to find the strongest signal for each FM station. If you are listening

to weak or distant FM Stereo station and reception is unsatisfactory, press the ST/MONO button to the FM

(Mono) on the remote control . This will normally provide an improvement in reception, although the sound

will no longer be in stereo.

AM - The AM ferrite bar antenna is located inside the cabinet. It may be necessary to turn the unit slightly

so that the internal antenna is point in the direction of the AM transmitter. You may have to experiment

to find the position that provides the strongest reception for each of your favorite AM stations.

Slide the POWER Switch to the ON

position. And Slide the FUNCTION

Switch to the RADIO position.

Press the BAND Button to a

desired setting - AM, FM.

NOTE: If you select either the

FM or FM Stereo bands, be sure

to raise the FM rod antenna and

extend it to its full length.

1 2 3

4 5

1

2

When you have finished listening,

Slide the POWER switch to

the OFF position to shut the power

off.

6

If the BAND Switch is set

to the FM STEREO positing and

you have tuned to an FM Stereo

station, the FM STEREO LED

Indicator will light.

FM MHz

ST

-6-

-7-

Betyg

Mer om denna bruksanvisning

Vi förstår att det är trevligt att ha en pappersbruksanvisning för din Sylvania SRCD4400 Stereoanläggning. Du kan alltid ladda ner bruksanvisningen från vår hemsida och skriva ut den själv. Om du vill ha en originalbruksanvisning rekommenderar vi att du kontaktar Sylvania. De kanske kan tillhandahålla en originalbruksanvisning. Letar du efter bruksanvisningen för din Sylvania SRCD4400 Stereoanläggning på ett annat språk? Välj ditt föredragna språk på vår hemsida och sök efter modellnumret för att se om vi har det tillgängligt.

Specifikationer

Alla bruksanvisningar för Sylvania Stereoanläggningar
Fler bruksanvisningar för Stereoanläggningar

Relaterade produkter

Bruksanvisning

Sylvania SRCD243P Stereoanläggning

Bruksanvisning

Sylvania SRCD904 Stereoanläggning

Bruksanvisning

Sylvania SRCD909 Stereoanläggning

Bruksanvisning

Sylvania SRCD5670 Stereoanläggning

Bruksanvisning

Sylvania SIP3050 Stereoanläggning

Bruksanvisning

Sylvania SRCD856 Stereoanläggning

Bruksanvisning

Sylvania SRCD544 Stereoanläggning

Bruksanvisning

Sylvania SRCD346 Stereoanläggning

Relaterade kategorier