Bruksanvisning Lanaform LA120123 Breva Luftfuktare

Bruksanvisning

3 / 40 English

ENGLISH

INTRODUCTION

Thank you for choosing the Breva cool mist

humidier by LANAFORM. The Brevahumid-

ier helps you restore a proper humidity lev-

el and eliminate the discomfort associated

with dry air. The ventilation system diuses

water in the form of cool vapour and there-

by provides the required level of humidity.



Please read all the

instructions before using your

humidier, especially this

basic safety information

This device is not intended for use by people,

including children, with reduced physical,

sensory or mental capabilities, or people with

a lack of experience or knowledge, unless

someone responsible for their safety can

supervise or instruct them beforehand on

how to use the device. Children should be

supervised to make sure they do not play

with the device.

Use this device only in accordance with the

instructions given in this manual.

Check that your mains voltage is the same

as that of your device.

Always place the Breva humidier on a hard,

at and horizontal surface. Keep it away from

walls (at least  cm) and heat sources such

as stoves, radiators, etc.



If it is not placed on a

horizontal surface, the device

may not work properly.

Do not connect or disconnect the plug of

the device with wet hands.

If the power cable is damaged, it must be

replaced by a similar cable available from

the supplier or the supplier’s after-sales

department.

Do not leave the device exposed to di-

rect sunlight.

Fill the reservoir with clean, fresh, distilled

or demineralised water.

Do not take the device apart either as a

whole or even its base unit.

Do not switch on the device when there is

no water in the reservoir.

Do not shake the device. This could cause

the water to spill over into the base unit and

prevent the device from working.

Never touch the water or components when

the unit is running.

If there is an unusual smell when the device

is being used as described in this manual,

switch o the device, unplug it and have it

examined by the supplier or the supplier’s

after-sales department.

Do not use essential oils with this device.

Do not pour hot water, i.e. water with a

temperature above °C, into the reservoir.

Unplug the device before cleaning it or re-

moving the reservoir.

Do not wash the entire unit with water

and do not immerse it in water. Consult

the cleaning instructions in this manual.

Never scrape the transducer with a hard

tool. The Breva humidier must be cleaned

regularly. To do this, consult the cleaning

instructions in this manual and follow them.

If it falls into water, unplug it immediately

before retrieving it.

Electrical appliances should never be left

unattended when connected. Unplug it

when you are not using it.

Keep the power cable away from hot surfaces.

Never use this appliance in a room in which

aerosols (sprays) are used or in a room where

oxygen is administered.

Use the humidier only when it is lled

with water.

Do not put items of clothing or towels on

top of the device. If the vapour emission

sprinkler tip is obstructed, this may cause

the device to malfunction.

Never point the vapour emission sprin-

kler tip towards electrical devices, books

or wooden objects that could present a

risk of mould.

When moving the device, lift it up by the

base and not by the water reservoir.

Do not use the humidier if the air in the

room is already suciently humid (relative

humidity of at least ). The ideal relative

humidity level for human comfort is between

 and . Excess humidity manifests

itself in condensation on cold surfaces or

on cold walls in the room. To measure the

room’s humidity correctly, use a hygrom-

eter available in most specialist shops and

hypermarkets.

The Breva humidier is designed for indoor

and domestic use only.

Use only the accessories supplied with this

device. The use of any unauthorised acces-

sory will not be covered by the warranty.

COMPONENTS OF

THE DEVICE 



1

1 Diuser sprinkler tip

2 Handle

3 Water reservoir

4 Anti-scaling lter

5 Water reservoir cap

6 Electrical cable and plug

7 Exhaust vent

8 Transducer

9 Touch control button

INSTRUCTIONS FOR USE

Before using the humidier

for the rst time

Remove the humidier from its original

packaging and make sure that it does not

have any faults. If you notice any faults, re-

turn the humidier to the supplier or the

supplier’s after-sales department.

Put the Breva humidier in the room for

half an hour before switching it on so that

it can adjust to room temperature.

The temperature of the room must always

be between °C and °C, and the temper-

ature of the water must be less than °C.

Fitting the anti-scaling lter

Attach the anti-scaling lter [



,



] to the

inner wall of the reservoir cap [



,



] by

turning it in a clockwise direction. Con

-

versely, to remove the anti-scaling lter,

turn it anticlockwise.

Instructions for use

Remove the diuser nozzle [



,



]. Then

remove reservoir [



,



] by removing the

handle [



,



] and invert it. Turn the res-

ervoir cap in an anti-clockwise direction to

open it

[



,



]

. Then pour clean, fresh, dis-

tilled or demineralised water into the reser-

voir. Replace the cap and turn in a clockwise

direction to close it tightly.

Fit the reservoir correctly on to the base

of the device and replace it with the dif-

fuser nozzle.

Make sure your hands are completely dry when

connecting and disconnecting the device.

Once the humidier is switched on, keep

your nger on the touch control button for

a few seconds [



,



].

The humidier is now working. Press the

touch control button to adjust the emission

of cool vapour to one of the three available

intensity levels. The corresponding LED in-

dicator will light up:

•

Purple for the lowest intensity (press

a rst time);

•

Green for medium intensity (press a

second time);

• Blue for high intensity – approximately

300 ml/hr (press a third time).

When there is no water left in the reservoir

or it has been removed from its base, the hu-

EN FR NL DE ES IT PL CS SK HU SL HR RU BG SV AR

E-IM-Breva-001-2018.indd 3 5/09/2018 09:16:39

Betyg

Mer om denna bruksanvisning

Vi förstår att det är trevligt att ha en pappersbruksanvisning för din Lanaform LA120123 Breva Luftfuktare. Du kan alltid ladda ner bruksanvisningen från vår hemsida och skriva ut den själv. Om du vill ha en originalbruksanvisning rekommenderar vi att du kontaktar Lanaform. De kanske kan tillhandahålla en originalbruksanvisning. Letar du efter bruksanvisningen för din Lanaform LA120123 Breva Luftfuktare på ett annat språk? Välj ditt föredragna språk på vår hemsida och sök efter modellnumret för att se om vi har det tillgängligt.

Specifikationer

Alla bruksanvisningar för Lanaform Luftfuktare
Fler bruksanvisningar för Luftfuktare

Vanliga frågor om Lanaform LA120123 Breva Luftfuktare

Vårt supportteam söker efter användbar produktinformation och svar på vanliga frågor. Om du hittar en felaktighet bland våra vanliga frågor uppskattar vi om du meddelar oss detta via vårt kontaktformulär.

Relaterade produkter

Bruksanvisning

Lanaform Mixy Luftfuktare

Bruksanvisning

Lanaform LA120122 Moony Luftfuktare

Bruksanvisning

Lanaform Trainy Luftfuktare

Bruksanvisning

Lanaform Family Care Luftfuktare

Bruksanvisning

Lanaform Vapolux Luftfuktare

Bruksanvisning

Lanaform Lily Luftfuktare

Bruksanvisning

Lanaform Hello Kitty Luftfuktare

Bruksanvisning

Lanaform Charly Luftfuktare

Relaterade kategorier