Bruksanvisning Ibico ibiMaster 250 Inbindningsmaskin

Bruksanvisning

ibiMaster 250 / ibiMaster 250e



Getting started

250 only: Push the handle (A) (fig. 1a) onto the

punching shaft located on the right side of the

machine. Align the flat spot of the handle with the flat

of the shaft.

Secure handle with screwdriver.

250e only: Firmly push the female end of the power

cord into the power cord receptacle located at the

back of the machine.

CAUTION: Make sure this step is complete prior to

plugging the male end of the power cord

into a power receptacle.

Plug the male end of the power cord into an

appropriate power receptacle.

1

2

3

4

Determine sheet width

Set Edge Guide (B) to paper size you wish to bind

(11”, 8-1/2” letter size, 11-1/4” oversized cover,

A4 ring, A5, Japan A4) (see figure 1a/1b).

1

250e only - Cleaning

CAUTION: Unplug this product before cleaning.



• Wipe exterior only with a damp cloth.

Do not use detergents or solvents.

The following notes apply only to the units

rated 230 V 50Hz.

MAIN CORDSET SELECTION

(FOR 230 AV MACHINES ONLY)

When choosing a detachable line cord for use with the

ibiMaster 250e, always observe the following:

The cordset consists of three components; the attachment

plug, cordage and appliance inlet. Each of these

components must meet European regulatory approvals

for safety.

The following

minimum electrical ratings for the specific

cordset are published for safety purposes.

DO NOT USE CORDSETS THAT DO NOT MEET THE

FOLLOWING MINIMUM ELECTRICAL REQUIREMENTS.

PLUG: 3 A, 250 Volts, 50/60 Hz, Class 1,3 conductor,

European safety agency approved.

CORDAGE: Type H05W-F3G0.75, Harmonized ( HAR ).

The “ ” symbols indicate cordage approved to

appropriate European standard (NOTE: "HAR" may be

substituted by the approval mark of the European safety

agency which approved the cordage. An example would

be “ VDE ”.

APPLIANCE CONNECTOR: 3 A, 250 Volts, 50/60 Hz,

European safety approved, Type IEC 320. Cordset shall not

exceed 3 meters in length. Cordset with component

electrical ratings greater than the minimum specified

electrical ratings may be substituted.

General safeguards

• Use the unit only for its intended purposes.

• Do not place anything in the punch opening of the

machine other than paper and cover stock.

• Place unit on a secure, stable work area to prevent the

unit from falling and possibly causing personal injury

and damage to the unit.

• Follow all warnings and instructions marked on the unit.

• Lift the machine from the bottom, not the cover.

• Do not lift the machine by the cover or paper holder

wire.



EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500

Betyg

Mer om denna bruksanvisning

Vi förstår att det är trevligt att ha en pappersbruksanvisning för din Ibico ibiMaster 250 Inbindningsmaskin. Du kan alltid ladda ner bruksanvisningen från vår hemsida och skriva ut den själv. Om du vill ha en originalbruksanvisning rekommenderar vi att du kontaktar Ibico. De kanske kan tillhandahålla en originalbruksanvisning. Letar du efter bruksanvisningen för din Ibico ibiMaster 250 Inbindningsmaskin på ett annat språk? Välj ditt föredragna språk på vår hemsida och sök efter modellnumret för att se om vi har det tillgängligt.

Specifikationer

Alla bruksanvisningar för Ibico Inbindningsmaskiner
Fler bruksanvisningar för Inbindningsmaskiner

Relaterade produkter

Bruksanvisning

Ibico ibiMaster 300 Inbindningsmaskin

Bruksanvisning

Ibico ibiMaster 250e Inbindningsmaskin

Bruksanvisning

GBC ThermaBind T500Pro Inbindningsmaskin

Bruksanvisning

Fellowes Pulsar-E 300 Inbindningsmaskin

Bruksanvisning

GBC WireBind Karo 40Pro Inbindningsmaskin

Bruksanvisning

Exibel T32004 Inbindningsmaskin

Bruksanvisning

GBC MultiBind 320 Inbindningsmaskin

Bruksanvisning

GBC CombBind C366E Inbindningsmaskin

Relaterade kategorier