Bruksanvisning Black and Decker BD146F3 Borrskruvdragare

Bruksanvisning

Warning! The battery fluid, a 25-30% solu -

tion of potassium hydroxide, can be harmful.

In case of skin contact, immediately rinse with

water. Neutralise with a mild acid such as lemon

juice or vinegar. In case of eye contact, rinse

abundantly with clean water for at least 10

minutes. Consult a physician.

- Do not incinerate the battery.

- Do not attempt to charge damaged batteries.

Chargers

- Use your Black & Decker charger only to

charge the battery in the tool with which it was

supplied. Other batteries could burst, causing

personal injury and damage.

- Never attempt to charge non-rechargeable

batteries.

- Have defective cords replaced immediately.

- Do not expose the charger to water.

- Do not open the charger.

- Do not probe the charger.

The charger is intended for indoor use only.

Electrical safety

Your charger is double insulated; therefore no

earth wire is required. Always check that

the mains voltage corresponds to the

voltage on the rating plate. Never attempt

to replace the charger unit with a regular

mains plug.

- Before drilling into walls, floors or ceilings,

check for the location of wiring and pipes.

- Avoid touching the tip of a drill bit just after

drilling, as it may be hot.

Features

This tool includes some or all of the following

features.

1. Variable speed switch

2. Forward/reverse slider

3. Mode selector / torque adjustment collar

4. Chuck

5. Two-gear selector

6. Bit holder

7. Battery

Fig. 1

8. Charger

9. Charging indicator

Assembly

Warning! Before assembly, remove the bat-

tery from the tool.

Fitting and removing the battery (fig. 2)

- To fit the battery (7), line it up with the recepta-

cle on the tool. Slide the battery into the recepta-

cle and push until the battery snaps into place.

- To remove the battery, push the release button

(11) while at the same time pulling the battery

out of the receptacle.

Fitting the battery cap (fig. 6)

Warning! Fit the cap (14) to the battery (7)

for transportation and storage.

Fitting and removing a drill bit or screwdriver

bit (fig. 4)

This tool is fitted with a keyless chuck to allow

for an easy exchange of bits.

- Lock the tool by setting the forward/reverse

slider (2) to the centre position.

- Open the chuck by turning the sleeve (4) with

one hand while holding the tool with the other.

- Insert the bit shaft (12) into the chuck.

- Firmly tighten the chuck by turning sleeve (4)

with one hand while holding the tool with the

other. This tool is supplied with a double-ended

screwdriver bit in the bit holder.

- To remove the screwdriver bit from the bit

holder, lift the bit from the recess.

- To store the screwdriver bit, firmly push it into

the holder.

Use

Warning! Let the tool work at its own pace.

Do not overload.

Warning! Before drilling into walls, floors

or ceilings, check for the location of wiring and

pipes.

Charging the battery (fig. 1)

The battery needs to be charged before first

use and whenever it fails to produce sufficient

6

Additional safety instructions for impact drills

Wear ear protectors with impact drills.

Exposure to

noise can cause hearing loss.

-

Warning! We recommend the use of a

residual current device with a residual current

rating of 30mA or less.

Betyg

Mer om denna bruksanvisning

Vi förstår att det är trevligt att ha en pappersbruksanvisning för din Black and Decker BD146F3 Borrskruvdragare. Du kan alltid ladda ner bruksanvisningen från vår hemsida och skriva ut den själv. Om du vill ha en originalbruksanvisning rekommenderar vi att du kontaktar Black and Decker. De kanske kan tillhandahålla en originalbruksanvisning. Letar du efter bruksanvisningen för din Black and Decker BD146F3 Borrskruvdragare på ett annat språk? Välj ditt föredragna språk på vår hemsida och sök efter modellnumret för att se om vi har det tillgängligt.

Specifikationer

Alla bruksanvisningar för Black and Decker Borrskruvdragare
Fler bruksanvisningar för Borrskruvdragare

Vanliga frågor om Black and Decker BD146F3 Borrskruvdragare

Vårt supportteam söker efter användbar produktinformation och svar på vanliga frågor. Om du hittar en felaktighet bland våra vanliga frågor uppskattar vi om du meddelar oss detta via vårt kontaktformulär.

Relaterade produkter

Bruksanvisning

Black and Decker BDCDD12USB Borrskruvdragare

Bruksanvisning

Black and Decker KC1451CN Borrskruvdragare

Bruksanvisning

Black and Decker BCD001 Borrskruvdragare

Bruksanvisning

Black and Decker KC1261F Borrskruvdragare

Bruksanvisning

Black and Decker BDCDMT108 Borrskruvdragare

Bruksanvisning

Black and Decker EPC148V Borrskruvdragare

Bruksanvisning

Black and Decker HP12KD Borrskruvdragare

Bruksanvisning

Black and Decker HP14KD Borrskruvdragare

Relaterade kategorier