Bruksanvisning Bionaire BFH3520 Värmefläkt

Behöver du en bruksanvisning för din Bionaire BFH3520 Värmefläkt? Nedan kan du se och ladda ner PDF-bruksanvisningen gratis på svenska. Den här produkten har för närvarande 2 vanliga frågor, 0 kommentarer och har 1 röst med ett genomsnittligt produktbetyg på 100/100. Om det här inte är bruksanvisningen du vill ha, vänligen kontakta oss.

Är produkten defekt och erbjuder bruksanvisningen ingen lösning? Gå till ett Repair Café för gratis reparationstjänster.

Bruksanvisning

Loading…

7. Do not use this heater with a programmer,
timer or any other device that switches the
heater on automatically, since a fire risk exists if
the heater is covered or positioned incorrectly.
8. Only touch the heater with dry hands.
9. DO NOT position where it can be touched by
children, especially the very young.
10. DO NOT use this heater outdoors.
11. Allow a safe area around the heater away from
furniture or other objects; at least 50 cm from
the top and sides and 200 cm at the front.
12. Do not use this heater when it is lying on its
side.
13. DO NOT use the heater in rooms with
explosive gas (e.g. petrol) or while using
inflammable glue or solvent (e.g. when gluing
or varnishing parquet floors, PVC etc.)
14. DO NOT insert any objects into the heater.
15. Keep the mains cord at a safe distance from
the main body of the heater.
16. If overheating should occur, the built-in
overheating safety device will switch off the
heater.
17. Do not place the cord under a rug.
18. The heater is to be installed so that switches
and other controls cannot be touched by a
person in the bath.
19. Avoid the use of an extension cord because
it may cause the heater to overheat.
For U.K. and Ireland only:
If the plug is not suitable for the socket outlets in
your home, it can be removed and replaced by a
plug of the correct type. Please refer to
"Installation of a plug" below.
Installation of a plug
Applicable to U.K. and Ireland
The wires in the mains lead are coloured as such:
BROWN - LIVE
BLUE - NEUTRAL
Please note that the colour of these mains wires
may not correspond with the colour markings
that identify the terminals in your plug. Please
proceed as follows:
The BROWN coloured wire must be connected
to the terminal, which is marked with the letter
"L" or is coloured RED.
The BLUE coloured wire must be connected to
the terminal, which is marked with the letter "N"
or is coloured BLACK.
DO NOT CONNECT either of these wires to the
earth terminal in the plug. The earth terminal
plug is marked with the letter "E", or with the
earth symbol or coloured GREEN and
YELLOW.
NOTE: If the terminals in the plug are not
marked or if you are unsure or in doubt about
the installation of the plug please contact a
qualified electrician. If a 13A 3-pin plug is fitted,
it must be an ASTA approved plug, conforming
to BS1363 standard. Replacement 13A fuses
must be BSI or ASTA BS1362 approved.
GUARANTEE
PLEASE KEEP YOUR RECEIPT AS THIS WILL
BE REQUIRED FOR ANY CLAIMS UNDER THIS
GUARANTEE.
This product is guaranteed for 2 years.
In the unlikely event of breakdown, please take
it back to the place of purchase, with your till
receipt and a copy of this guarantee.
The rights and benefits under this guarantee
are additional to your statutory rights which
are not affected by this guarantee.
Holmes Products Europe undertakes within
the specific period, to repair or replace free of
charge, any part of the appliance found to be
defective provided that:
•We are promptly informed of the defect.
The appliance has not been altered in any
way or subjected to misuse or repair by a
person other than a person authorised by
Holmes Products Europe.
No rights are given under this guarantee to a
person acquiring the appliance second hand
or for commercial or communal uses.
Any repaired or replaced appliance will be
guaranteed on these terms for the remaining
portion of the guarantee.
THIS PRODUCT IS MANUFACTURED TO
COMPLY WITH THE E.E.C. DIRECTIVES
73/23/EEC, 89/336/EEC AND 98/37/EEC.
Waste electrical products should
not be disposed of with
Household waste. Please recycle
where facilities exist. Check on
the following website for further
recycling and WEEE information:
www.bionaire.com/europe or
e-mail info-europe@theholmesgroup.com.
4
DESCRIPTIONS:
A. Heizlüftergehäuse
B. Gewindestück
C. 2-teilige Sockelstange
D. Basis
E. Sicherungsmutter
F. Stromkabel
G. Fernbedienungssensor
H. Betriebskontrollleuchte
I. Modustaste
J. Oszillatortaste
K. Temperaturregler-/Zeitgebereinstelltasten
+ (nach oben)
- (nach unten)
L. Zeitgebertaste
MONTAGEANLEITUNG (SIEHE ABB. 1, 2)
Wenn Sie das Gerät mit Sockelstange einsetzen
möchten, beginnen Sie mit Schritt 1.
Schritt 1 – Drehen Sie das Heizlüftergehäuse
(A)um und legen Sie es auf einen
festen, ebenen Untergrund.
Schritt 2 – Schrauben Sie die Sicherungsmutter
(E) ab, indem Sie sie gegen den
Uhrzeigersinn drehen. Schieben Sie
die Sicherungsmutter (E) und den
Standfuß (D) ans Ende des
Stromkabels.
Schritt 3 – Klappen Sie die Sockelstange (C) auf
und stecken Sie die beiden Hälften
(C) um das Stromkabel herum wieder
zusammen. Setzen Sie die beiden
Befestigungsschrauben ein. (siehe
Abbildung 1).
Schritt 4 – Schrauben Sie die Sockelstange (C)
im Uhrzeigersinn auf das
Gewindestück (B) auf der Unterseite
des Heizlüftergehäuses (A), bis Sie
einen Widerstand spüren. (siehe
Abbildung 2).
Schritt 5 – Schieben Sie den Standfuß (D) und die
Sicherungsmutter (E) am Stromkabel
hinauf, wobei die glatte Seite nach
oben zeigen sollte. Achten Sie darauf,
den Punkt auf der Rückseite des
Standfußes auf den Punkt an der
Sockelstange auszurichten, bevor Sie
die Sicherungsmutter (E) anziehen
(siehe Abbildung 2).
Schritt 6 – Salten Sie den Standfuß (D) gerade
und ziehen Sie die Sicherungsmutter
(E) durch Drehen im Uhrzeigersinn an.
Schritt 7 – Führen Sie das Stromkabel durch die
Auskerbung auf der Rückseite des
Standfußes.
Schritt 8 – Drehen Sie den Heizlüfter vorsichtig
um und stellen Sie ihn auf einen
festen, ebenen Untergrund.
INBETRIEBNAHME
Frostwächter
Diese spezielle Funktion wird automatisch
aktiviert, wenn der Modus (AF) ausgewählt ist. In
diesem Modus bleibt das Gerät ausgeschaltet,
bis die Raumtemperatur sich dem Gefrierpunkt
nähert. Dann wird das Heizgerät automatisch
auf höchster Heizleistung (HI) eingeschaltet. Das
Gerät schaltet sich immer wieder ein und aus,
da es die Temperatur zwischen 5 °C und 8 °C
hält.
Einstellen des Lüfters
Drücken Sie einmal die Modustaste ( ) um nur
den Lüfter (FA) einzuschalten.
Einstellung des digitalen Thermostats:
Ihr Heizgerät ist mit einem digitalen Thermostat
ausgestattet, mit dem Sie Ihren Komfortbereich
präzise einstellen können.
1. Drücken Sie die Modus-Taste ( ) einmal,
um den manuellen Modus und die höchste
Heizleistung (HI) einzustellen. Der Heizlüfter
läuft dann kontinuierlich auf höchster Stufe.
2. Drücken Sie die Modus-Taste nochmals, um
den manuellen Modus und die niedrigste
Stufe (LO) einzustellen. Der Heizlüfter läuft
dann kontinuierlich auf niedrigster Stufe.
3. Drücken Sie die Modus-Taste ein drittes Mal,
um den Auto-Modus und die höchste Stufe
einzustellen (AH), oder drücken Sie sie ein
weiteres Mal, um den Auto-Modus und die
niedrigste Stufe (AL) einzustellen. In beiden
Modi können Sie dann mithilfe der (+)- und (-)-
Tasten die gewünschte Temperatur einstellen.
4. Nach Einstellung der gewünschten Temperatur
wird in der Anzeige wieder die aktuelle
Raumtemperatur angezeigt. Diese (und
dementsprechend die angezeigte Temperatur)
erhöht sich dann allmählich, bis die
voreingestellte Temperatur erreicht ist.
5. Wenn das Gerät sich im Modus mit digitalem
Thermostat nicht einschaltet, prüfen Sie,
ob die eingestellte Temperatur höher als
die aktuelle Raumtemperatur ist.
HINWEIS: Es ist normal, dass sich das
Heizgerät immer wieder ein- und ausschaltet,
da es die voreingestellte Temperatur
beibehält. Wenn Sie das wiederholte Ein-
/Ausschalten vermeiden möchten, müssen
Sie die Thermostateinstellung erhöhen.
Wenn die voreingestellte Temperatur erreicht
ist, läuft der Ventilator 30 Sekunden lang
ohne Heizleistung weiter. Durch diesen
5
13 amp
DEUTSCH
Ladda ner bruksanvisning i Svenska (PDF, 0.99 MB)
(Tänk på miljön och skriv endast ut denna bruksanvisning om det verkligen är nödvändigt)

Loading…

Betyg

Berätta vad du tycker om Bionaire BFH3520 Värmefläkt genom att betygsätta den. Vill du dela med dig av dina åsikter om denna produkt eller ställa en fråga? Lämna en kommentar nederst på sidan.
Är du nöjd med Bionaire BFH3520 Värmefläkt?
Ja Nej
100%
0%
1 röst

Delta i konversationen om denna produkt

Här kan du dela vad du tycker om Bionaire BFH3520 Värmefläkt. Om du har en fråga, läs först noggrant igenom manualen. Att begära en manual kan göras genom att använda vårt kontaktformulär.

Mer om denna bruksanvisning

Vi förstår att det är trevligt att ha en pappersbruksanvisning för din Bionaire BFH3520 Värmefläkt. Du kan alltid ladda ner bruksanvisningen från vår hemsida och skriva ut den själv. Om du vill ha en originalbruksanvisning rekommenderar vi att du kontaktar Bionaire. De kanske kan tillhandahålla en originalbruksanvisning. Letar du efter bruksanvisningen för din Bionaire BFH3520 Värmefläkt på ett annat språk? Välj ditt föredragna språk på vår hemsida och sök efter modellnumret för att se om vi har det tillgängligt.

Specifikationer

Märke Bionaire
Modell BFH3520
Kategori Värmefläktar
Filtyp PDF
Filstorlek 0.99 MB

Alla bruksanvisningar för Bionaire Värmefläktar
Fler bruksanvisningar för Värmefläktar

Vanliga frågor om Bionaire BFH3520 Värmefläkt

Vårt supportteam söker efter användbar produktinformation och svar på vanliga frågor. Om du hittar en felaktighet bland våra vanliga frågor uppskattar vi om du meddelar oss detta via vårt kontaktformulär.

Hur påverkar damm effektiviteten hos en värmare? Verifierad

Damm kan samlas på värmeelementen och i luftfiltren på en värmare, vilket minskar dess effektivitet. Detta kan få värmaren att arbeta hårdare för att producera samma mängd värme, vilket leder till ökad energiförbrukning och högre elräkningar. För att upprätthålla effektiviteten hos din värmare, se till att rengöra den regelbundet och byt ut luftfiltret vid behov.

Detta hjälpte (107) Läs mer

Hur bestämmer jag storleken på värmaren jag behöver för ett rum? Verifierad

Storleken på värmaren du behöver för ett rum beror på rummets storlek och utrymmets isolering. En allmän tumregel är att använda 60 watt per kvadratmeter utrymme. Till exempel, om ett rum är 14 kvadratmeter, skulle en 840-watts värmare vara lämplig.

Detta hjälpte (64) Läs mer
Bruksanvisning Bionaire BFH3520 Värmefläkt

Relaterade produkter

Relaterade kategorier