Bruksanvisning Big Agnes Copper Spur UL4 Tält

Behöver du en bruksanvisning för din Big Agnes Copper Spur UL4 Tält? Nedan kan du se och ladda ner PDF-bruksanvisningen gratis på svenska. Den här produkten har för närvarande 7 vanliga frågor, 0 kommentarer och har 0 röster. Om det här inte är bruksanvisningen du vill ha, vänligen kontakta oss.

Är produkten defekt och erbjuder bruksanvisningen ingen lösning? Gå till ett Repair Café för gratis reparationstjänster.

Bruksanvisning

Loading…

Cut here to remove. Do Not Tear!
COPPER SPUR UL SETUP INSTRUCTIONS
1. Remove contents from stu sack. Spread the tent body out at on the ground.
2. Assemble the two poles: One main pole with two hubs and one short straight
crossover pole. To ensure each pole section is fully seated insert each pole section
into the next by hand, instead of allowing the shock cord to snap them together.
3. Position the assembled pole set on top of the tent body. CS1 & CS2: Align the or-
ange pole segments of the main pole set with the orange webbing at the foot of
the tent. CS3 & CS4: The pole set is symmetrical so the pole tips may be inserted
at either end.
4. Insert the pole tips into the grommets at the four corners of the tent.
5. Attach the H Clip on the top-center of the tent body to the Swivel CH hub on the
main pole. CS1: Attach H Clip to Swivel H.
6. Attach the Twist Clips on the tent body to the main pole.
7. Place the crossover pole across the top of the ridge pole and into the top of the
Swivel CH for CS2, CS3, & CS4. The cross pole on the CS1 is already attached to the
main pole.
8. CS1, CS2, CS3: Clip the ends of the crossover pole into the clear plastic Ball Cap
clips that are located above the doors on the tent body. CS4: Attach the H Clips
above the doors of the tent body to the S Stoppers on the cross pole.
9. Stake out the four corners of the tent body.
10. Drape the rainy over the tent body. CS & CS2: Align the silver and orange web-
bing straps on the rainy with those on the corners of the tent body. CS3 & CS4:
Align the doors on the y with the doors on the tents body.
11. CS4: Insert the tips of the cross pole into the webbing pockets located on the
underside of the y. Note: CS1, CS2 and CS3: The webbing pockets are used in
the Fast Fly set up only.
12. Make sure the webbing at the corners of the rainy is completely slackened. At-
tach the buckles on the rainy to those on the tent body.
13. Stake out the vestibules.
14. Evenly tension the webbing on each corner as needed to keep the rainy taut.
15. Stake out all guylines.
Separate 6”, large diameter pole segment included for emergency
eld repair. Slide repair pole over the break to act as a splint.
FAST FLY SET UP INSTRUCTIONS
If you purchase the optional Big Agnes footprint for any of our models, it will
enable you to pitch a Fast Fly shelter while leaving the tent body behind. The Fast
Fly conguration requires the footprint, tent y, poles and stakes.
1. Lay the footprint on the ground and stake out.
2. Assemble the two poles: One main pole with two hubs and one short straight
crossover pole. To ensure each pole section is fully seated insert each pole
section into the next by hand, instead of allowing the shock cord to snap them
together.
3. Position the assembled pole set on top of the footprint. CS1 & CS2: Align the
orange pole segments of the main pole set with the orange webbing on the
footprint. CS3 & CS4: The main pole has equal length pole sections so the pole
tips may be inserted at either end.
4. Insert the pole tips into the grommets at the four corners of the footprint.
5. Place the crossover pole across the top of the ridge pole and into the top of the
Swivel CH for CS2, CS3, & CS4. The cross pole on the CS1 is already attached to
the main pole.
6. Drape the rainy over the pole frame aligning the silver webbing on y with the
silver webbing on the footprint. Insert the tips of the cross pole into the web-
bing pockets located on the underside of the y.
7. Make sure the webbing at the corners of the rainy is completely slackened. At-
tach the buckles on the rainy to those on the footprint.
8. Stake out the vestibules.
9. Evenly tension the webbing on each corner as needed to keep the rainy taut.
10. Stake out all guylines.
Copper Spur UL1
Tent Body
Copper Spur UL1
Tent Fly
Ball Cap Swivel CH
H Clip Twist Clip
Swivel H S Stopper
Hardware:
Copper Spur UL3
Tent Body
Copper Spur UL4
Tent Body
Copper Spur UL4
Tent Fly
Copper Spur UL3
Tent Fly
Copper Spur UL2
Tent Body
Copper Spur UL2
Tent Fly
Ladda ner bruksanvisning i Engelska (PDF, 0.86 MB)
(Tänk på miljön och skriv endast ut denna bruksanvisning om det verkligen är nödvändigt)

Loading…

Betyg

Berätta vad du tycker om Big Agnes Copper Spur UL4 Tält genom att betygsätta den. Vill du dela med dig av dina åsikter om denna produkt eller ställa en fråga? Lämna en kommentar nederst på sidan.
Är du nöjd med Big Agnes Copper Spur UL4 Tält?
Ja Nej
Bli den första personen som betygsätter denna produkt
0 röster

Delta i konversationen om denna produkt

Här kan du dela vad du tycker om Big Agnes Copper Spur UL4 Tält. Om du har en fråga, läs först noggrant igenom manualen. Att begära en manual kan göras genom att använda vårt kontaktformulär.

Mer om denna bruksanvisning

Vi förstår att det är trevligt att ha en pappersbruksanvisning för din Big Agnes Copper Spur UL4 Tält. Du kan alltid ladda ner bruksanvisningen från vår hemsida och skriva ut den själv. Om du vill ha en originalbruksanvisning rekommenderar vi att du kontaktar Big Agnes. De kanske kan tillhandahålla en originalbruksanvisning. Letar du efter bruksanvisningen för din Big Agnes Copper Spur UL4 Tält på ett annat språk? Välj ditt föredragna språk på vår hemsida och sök efter modellnumret för att se om vi har det tillgängligt.

Specifikationer

Märke Big Agnes
Modell Copper Spur UL4
Kategori Tält
Filtyp PDF
Filstorlek 0.86 MB

Alla bruksanvisningar för Big Agnes Tält
Fler bruksanvisningar för Tält

Vanliga frågor om Big Agnes Copper Spur UL4 Tält

Vårt supportteam söker efter användbar produktinformation och svar på vanliga frågor. Om du hittar en felaktighet bland våra vanliga frågor uppskattar vi om du meddelar oss detta via vårt kontaktformulär.

Kan jag lagra mitt tält när det är vått? Verifierad

Endast under mycket korta perioder. När ett tält lagras i vått tillstånd i en vecka eller längre kan det bli mögligt. Detta är skadligt för ditt tält och eventuellt din hälsa.

Detta hjälpte (515) Läs mer

Hur impregnerar jag ett tält? Verifierad

Sätt upp tältet, rengör trasan och låt den torka. Applicera impregneringsmedlet på duken med en växtspruta eller annan spray. Det är också möjligt att använda en målarulle eller pensel. Duken måste vara helt mättad med impregneringsmedlet. Behandla också tältets insida. Rengör fönster noggrant med en fuktig trasa. Låt inte impregneringsmedlet torka på det. Låt tältduken torka helt. Upprepa behandlingen om det behövs.

Detta hjälpte (409) Läs mer

Kan jag reparera ett tår eller hål i tältets duk själv? Verifierad

Det finns speciella bitar av självhäftande tyglappar tillgängliga för syntetiska tygdukar. Stick en av dessa fläckar på båda sidor av hålet eller riv. För tygdukar av bomull eller tygdukar av blandat material är det bäst att använda lappar som kan strykas på. Detta kräver strykjärn.

Detta hjälpte (264) Läs mer

Dragkedjan i mitt tält går inte smidigt, vad kan jag göra? Verifierad

När en blixtlås går smidigt, använd en torr PTFE-spray eller silikonspray. Spraya inte på trasan och spray förebyggande för att undvika framtida problem.

Detta hjälpte (207) Läs mer

Vilka tältpinnar är bäst att använda för vilka ytor? Verifierad

På gräsmark- eller skogsytor kan du använda halvcirkelformiga eller plastpinnar. På steniga ytor måste du använda stenpinnar. På leraytor kan du använda halvcirkelformade, plastiska eller universella pinnar. På grusytor behöver du halvcirkelformiga eller universalpinnar och på sand måste du använda träpinnar.

Detta hjälpte (196) Läs mer

Det finns vattendroppar på insidan av tältet, betyder det att det läcker? Verifierad

Nej, det här är förmodligen kondens. Se till att tältet är ordentligt ventilerat för att hålla kondens på ett minimum.

Detta hjälpte (175) Läs mer

Impregneringsmedlet lämnar vita fläckar eller en vit dis på tältduken. Vad kan jag göra åt detta? Verifierad

Om agenten lämnar en vit dis eller vita fläckar på tältduken betyder det att du har applicerat mer impregneringsmedel på dessa områden. Detta är inte skadligt och fläckarna försvinner ofta med tiden. Det är inte tillrådligt att använda mindre impregneringsmedel för att förhindra fläckar. Duken måste vara helt mättad med impregneringsmedlet för att ge bra resultat.

Detta hjälpte (131) Läs mer
Bruksanvisning Big Agnes Copper Spur UL4 Tält

Relaterade produkter

Relaterade kategorier

×
Download