♦ If the supply cord is damaged, it must be replaced by manufacturer or its service agent or similarly qualified
personnel in order to avoid a hazard.
♦ Not for space heating purpose.
♦ The output nozzle becomes very hot during operation (200°C). Keep flammable materials at least 50 cm
away from the nozzle.
♦ Always allow your ANTARI Fog Machine to cool down before attempting to clean or service it.
Danger of Explosion
♦ Never add flammable liquids of any kind (such as oil, gas, perfume) to the fog liquid.
♦ Use only high-quality, water-based fog liquid that your dealer recommends. Other fog liquids may cause
clogging or “spitting”.
♦ Always make sure there is sufficient liquid in the tank. Operating this unit without liquid will cause damage to
the pump as well as over-heating of the heater.
♦ If your ANTARI Z-800II, Z-1000II and Z-1020 Fog Machine fails to work properly, discontinue use
immediately. Drain all fog liquid from the tank, pack the unit securely (preferably in the original packing
material), and return it to your ANTARI dealer for service.
♦ Always drain tank before mailing or transporting this unit.
♦ Never drink fog liquid. If it is ingested, call a doctor immediately. If fog liquid comes in contact with skin or
eyes, rinse thoroughly with water.
Note: Pay attention to all warning labels and instructions printed on the exterior of your ANTARI Fog Machine
Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact.
The shipping carton should contain the following items:
1. One unit of Z-Series II Fog Machine
2. Power cord
3. Z-10 Remote Control
4. User Manual
5. Mounting brackets with washers/screws (for Z-1000II)
If any equipment is missing contact your ANTARI dealer immediately.
Before beginning your initial setup on ANTARI Z-800II, Z-1000II or Z-1020 Fog Machine, make sure that there is
no evident damage caused by transportation. In the event that the unit’s housing or cable is damaged, do not
plug it in and do not attempt to use it until after contacting your ANTARI dealer for assistance.
Setup
♦ Remove all packing materials from shipping box. Check that all foam and plastic padding is removed,
especially in the nozzle area.
♦ Place fog machine on a flat surface and remove fog liquid tank cap.
♦ Fill with high-quality, water-based fog liquid recommended by ANTARI dealer. Any other types of fluid can
damage the unit resulting in spitting and serious clogging problem. When filled, place cap back on liquid
tank. Be careful not to exceed the maximum fluid level. DO NOT OVERFILL.
♦ Firmly attach the remote control cable to the proper input on the back of the machine.
Operation
♦ Add fluid carefully to the liquid tank. Do not overfill the tank.
♦ Plug power cord into a grounded electrical outlet. Turn the power switch to “ON” on the back of the machine.
The unit will take a couple of minutes to warm up the heater. During this time the machine cannot generate
fog. When the remote control is attached the red lights (on Z-800II handle) and green light (on the remote)
will flash and stay ON when the warm-up time is complete.
♦ To emit fog press the button on the remote (if it is connected) and on the handle (for Z-800II) for the desired
length of time.
Delta i konversationen om denna produkt
Här kan du dela vad du tycker om Antari Z-1000II Rökmaskin. Om du har en fråga, läs först noggrant igenom manualen. Att begära en manual kan göras genom att använda vårt kontaktformulär.