Bruksanvisning Aiwa VX-S137 TV

Bruksanvisning

ENGLISH

OWNER'S RECORD

For your convenience, record the model number and

serial number (you will find them on the rear of your set)

in the space provided below. Please refer to them when

you contact your AIWA dealer in case of difficulty.

Model No.

Serial No.

2

ANTENNA LEAD IN WIRE

ANTENNA DISCHARGE

UNIT

(NEC SECTION 810-20)

GROUNDING

CONDUCTORS

(NEC SECTION 810-21)

GROUND CLAMPS

POWER SERVICE GROUNDING

ELECTRODE SYSTEM

(NEC ART 250 PART H)

NEC-NATIONAL ELECTRICAL CODE

ELECTRIC

SERVICE

EQUIPMENT

GROUND CLAMP

Antenna Grounding According to the National Electrical Cord

Overloading - Do not allow anything to rest on the power

cord. Do not overload wall outlets and extension cords

because this can result in fire or electric shock. Do not place

the unit in an area where people will walk on the cord.

Outdoor Antenna

Power lines - An outside antenna system should not be

located in the vicinity of overhead power lines or other

electric light or power circuits, or where it can fall onto such

power lines or circuits. When installing an outside antenna

system, extreme care should be taken to avoid touching

power lines or circuits because contact with them may be

fatal.

Outdoor Antenna Grounding - If an outside antenna or

cable system is connected to the unit, be sure the antenna

or cable system is grounded so as to provide some

protection against voltage surges and built-up static

charges. Section 810 of the National Electrical Code, ANSI/

NFPA No.70, provides information with regard to proper

grounding of the mast and supporting structure, grounding

of the lead-in wire to an antenna discharge unit, size of

grounding conductors, location of antenna-discharge unit,

connection to grounding electrodes, and requirements for

the grounding electrode. See the figure.

Lightning

For added protection during a lightning storm, or when left

unattended and unused for long periods of time, unplug the

unit from the wall outlet and disconnect the antenna or cable

system. This will prevent damage to the unit due to

lightning and powerline surges.

Maintenance

Cleaning - Unplug the unit from the wall outlet before

cleaning. Do not use liquid cleaners or aerosol cleaners.

Use a damp cloth for cleaning.

Condensation

If the unit is brought directly from a cold to a warm location,

moisture may condense inside the unit and cause damage

to the video heads and tapes played on it. When you first

install the unit, or when you move it from a cold to a warm

location, wait for about two hours before operating the unit.

Damage Requiring Service

Unplug the unit from the wall outlet and refer servicing to

qualified service personnel under the following conditions:

1) When the power cord or plug is damaged or frayed.

2) If liquid has been spilled into the unit.

3) If the unit has been exposed to rain or water.

4) If the unit does not operate normally when following

the operating instructions. Adjust only those controls

that are covered by the operating instructions because

improper adjustment of other controls may result in

damage to the unit and will often require extensive

work by a qualified technician to restore the unit to

normal operation.

5) If the unit has been dropped or the cabinet has been

damaged.

6) When the unit exhibits a distinct change in

performance - this indicates a need for service.

Do not attempt to service the unit yourself because opening

or removing covers may expose you to high voltage or other

hazards. Refer all servicing to qualified service personnel.

Replacement Parts - When replacement parts are required,

be sure the service technician has used replacement parts

specified by the manufacturer or having the same

characteristics as the original part. Unauthorized

substitutions may result in fire, electric shock or other

hazards.

Safety Check - After completion of any service or repairs to

the unit, ask the service technician to perform a safety

check to ensure that the unit is in proper operating

condition.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s

attention to Article 820-40 of the NEC that provides

guidelines for proper grounding and, in particular, specifies

that the cable ground should be connected to the grounding

system of the building, as close to the point of cable entry as

practical.

Betyg

Mer om denna bruksanvisning

Vi förstår att det är trevligt att ha en pappersbruksanvisning för din Aiwa VX-S137 TV. Du kan alltid ladda ner bruksanvisningen från vår hemsida och skriva ut den själv. Om du vill ha en originalbruksanvisning rekommenderar vi att du kontaktar Aiwa. De kanske kan tillhandahålla en originalbruksanvisning. Letar du efter bruksanvisningen för din Aiwa VX-S137 TV på ett annat språk? Välj ditt föredragna språk på vår hemsida och sök efter modellnumret för att se om vi har det tillgängligt.

Specifikationer

Alla bruksanvisningar för Aiwa TV
Fler bruksanvisningar för TV

Vanliga frågor om Aiwa VX-S137 TV

Vårt supportteam söker efter användbar produktinformation och svar på vanliga frågor. Om du hittar en felaktighet bland våra vanliga frågor uppskattar vi om du meddelar oss detta via vårt kontaktformulär.

Relaterade produkter

Bruksanvisning

Aiwa TV-F2400u TV

Bruksanvisning

Aiwa VX-S205 TV

Bruksanvisning

Aiwa TV-C1300u TV

Bruksanvisning

Aiwa VX-S207 TV

Bruksanvisning

Aiwa TV-S2700 TV

Bruksanvisning

Aiwa TV-F2000u TV

Bruksanvisning

Aiwa VX-C131 TV

Bruksanvisning

Aiwa VX-S135 TV

Relaterade kategorier