CLEANING
Do not immerse in any liquid.
Never use abrasive cleaners, brushes,
gasoline, kerosene, glass / furniture polish or
paint thinner to clean.
Unplug the unit and allow it to cool down before
cleaning. Clean only with a soft, slightly damp
sponge. Never allows water or any other liquids to
come into contact with the unit.
•
•
Do not attempt to repair the Massage Seat with
Heat. There are no user serviceable parts.
3
1.
2.
1.
2.
1.
2.
1.
2.
Press Full, Upper or Lower button to
choose the massage area as needed. The
corresponding LED light will illuminate. Press
the same button to deselect and the LED
indicator light will turn off.
Press the STRENGTH button to turn on the
seat massage. The corresponding LED light
indicator will be on.
Press the button multiple times to toggle
through massage strength of low, medium,
high and seat massage off option. The LED
light indicator will be turned off when the seat
massage is off.
GETTING STARTED
STORING
MAINTENANCE
Place the unit in its box or in a safe, dry, cool place.
Refrain from sharp edges or pointed objects that
might cut or puncture the fabric surface. To avoid
breakage, do not wrap the power cord around the
unit. Do not hang the unit by the power cord or the
cord of the remote control unit.
For a brief demonstration of the features of the
Massage Seat, press the DEMO button. The unit
will start a cycle of kneading back massage. Once
complete the unit automatically turns off.
Preparing the units for your rst time use
The Massager comes with 2 screws located
on the back of the unit to protect the unit’s
mechanism during shipment. These screws must
be removed before the rst use to avoid damage.
Use the provided allen key to remove the screws
and then use the provided black plug to ll the
hole. Dispose the screws appropriately.
When using the unit for the rst time, you will hear
a “pop” sound. This indicates that the secure lock
has been unlocked. This only happens when the
unit is used for the rst time.
CONNECTING TO MAINS
SEAT MASSAGER
DEMO MODE
Connect power adaptor to mains.
Connect the DC jack to the power adaptor.
TURNING ON THE MASSAGER
CHOOSING MASSAGE ZONES
MASSAGE WITH HEAT FUNCTION
Press the POWER button to turn the unit on.
The LED indicator light will illuminate and
conrm you selection.
To turn off the massager, press the POWER
button again. The LED indicator light will blink
while the massage nodes are returning to the
starting position.
After chosen the massage program, press the
HEAT button to turn on the heat function. The
corresponding LED indicator light will turn on.
Press the same button to deselect the heat
and the LED indicator light will turn off.
WARNING
WARNING
Do not pull the power cord or wrap it around
the unit.
Do not sit on the power cord.
•
•
1.
2.
WARNING
The massage mechanism always returns
to the starting position when the massage course
ends and when the unit is turned off at the control
panel. If the electrical supply is interrupted, when
the power restores, the mechanism will go back to
the original point before a new massage begins.
Press POWER to begin a new massage.
For your safety, the heat function cannot
be turned on alone without any massage program
chosen.
The massager will turn off automatically
after 15 minutes operation to prevent the unit
overheating.
NOTE
NOTE
NOTE
EN
RECOMMENDED MASSAGE TIME
Generally, a back massage could take up to 15
minutes. You may choose to use it once or twice
daily as needed.
If you have any doubts or concerns, always
consult your doctor.
Delta i konversationen om denna produkt
Här kan du dela vad du tycker om Oregon IBM80021 Massageapparat. Om du har en fråga, läs först noggrant igenom manualen. Att begära en manual kan göras genom att använda vårt kontaktformulär.