Home > Telecommunikation > Walkie-talkie > Exibel Walkie-talkie > Exibel FX-122 Walkie-talkie

Bruksanvisning Exibel FX-122 Walkie-talkie

Behöver du en bruksanvisning för din Exibel FX-122 Walkie-talkie? Nedan kan du se och ladda ner PDF-bruksanvisningen gratis på svenska. Den här produkten har för närvarande 0 vanliga frågor, 0 kommentarer och har 0 röster. Om det här inte är bruksanvisningen du vill ha, vänligen kontakta oss.

Är produkten defekt och erbjuder bruksanvisningen ingen lösning? Gå till ett Repair Café för gratis reparationstjänster.

Bruksanvisning

GREAT BRITAIN

For consumer contact, please visit www.clasohlson.co.uk and click on customer service.

DCM

DCS

VOX

DCM

DCS

VOX

Speaker

Microphone

[MENU]

Shows menus

[CALL]

Call with tone

or melody

[PTT]

Transmit button

(Push To Talk))

Display

Antenna

Jack for headset

[PWR]

Power button.

Switches

device on

or off

[▼] [▲]

UP/DOWN

Volume/function

selector

Charger jack

(DC 7.5 V, 750 mA)

Channel

indicator (1-8)

Subtone indicator

(1-38)

Battery indicator

(symbol full =

good battery)

2. Buttons and functions

Fig. 2Fig. 1

PMR

Art. No 38-3789 Model FX-122

Read through the entire instructions carefully before using

the device and keep them for future use. We disclaim all

responsibility for any errors in texts, pictures and diagrams,

or modiﬁcations of technical data. For technical problems

or other questions please contact our Customer Service

(see address information on reverse side).

PMR446

PMR446 is a license-exempt frequency band. Be conside-

rate, as there may be other users on the same channel.

Area of coverage/Range

The range depends on the surrounding terrain. The range

is widest in open terrain without obstructions (hills, moun-

tains, buildings, etc.). To avoid interference, radios should

not be used at distances less than 1.5 m from one another.

1. Safety

• Never expose radio, charger or power adapter to

moisture or dampness.

• Use only the enclosed or a recommended charger

• Use only the enclosed battery pack in the device when

charging. Charging other batteries does not work.

• If you use the headset you should refrain from listening

at top volume to protect your hearing.

• Always remove batteries when the device is not

in use for long periods.

• To reduce the risk of exposure to radio wave radiation,

always hold the radio at least 5 cm from your face

when transmitting.

• Do not use the radio if the antenna is damaged.

• Switch off the radio when requested to do so – for

example, during detonations or when there is risk of

explosion from ﬂammable materials, gases or liquids.

3. Getting started

3.1 Insert battery pack

2.1 Display

TX Transmitting symbol

RX Receiving symbol

DCM Monitoring of two channels are activated

DCS Shows that DCS (Digital Code System,

digital subtone) is activated.

VOX Voice-activated transmission is on

SC Channels being scanned (Scan)

DCM

DCS

VOX

Button lock activated

DCM

DCS

VOX

Volume level

TX Ringtone activated

DCM

DCS

VOX

Timing function (stopwatch function) activated

a. Open the catch on the battery compartment

by applying pressure and sliding the battery

cover downward.

b. Insert the battery pack as in (Fig. 1). Connect the cable

from the battery pack to the contact on the right side

at the bottom of the battery compartment,

c. Replace the battery cover (Fig. 2).

3.2 Charging

a. Connect the DC contact

on the enclosed power

adapter to the input

marked ”DC 7.5 V,

750 mA” on the back

of the charger. Then

connect the power

adapter to a wall socket.

Use only the enclosed

power adapter.

b. Place one or both radios in an upright position

in charger pocket. The LED for each battery

compartment or both is illuminated during charging.

A fully empty battery pack takes approx. 4 hours to charge

fully. New battery packs should be charged for ca. 5 hours

before they are ﬁrst used.

Tip! Switch off radios during charging. This shortens

charging time.

Charging directly in the radio

• Charging can also take place directly in the radio

without placing the radio in the charging pocket.

• To do so, you must connect the DC contact on

the power adapter to the jack on the underside of

the device.

3.3 Battery indicator on the display

Battery indicator on the display shows the percentage

charge on the battery.

Explanation of battery indicator on the display:

Fully charged

Half-charged

Low charge When on the radio emits a beep

every ten seconds. It is then time to charge the

battery.

Very low charge The radio emits two short

beeps and then shuts off. Place the radio in

the charger to charge the battery again.

Note! Always let the battery charge for four hours

to achieve a full charge.

4. Use

4.1. The range

The range depends on the surrounding terrain. The range

is widest in open terrain without obstructions (hills, moun-

tains or buildings, etc.). To avoid interference, radios should

not be used at distances less than 1.5 m from one another.

Important safety information

To reduce the risk of exposure to radiation from radio

waves, always hold the radio at least 5 cm from your face

when transmitting.

4.2 Switching radio on and off

Switch the radio on by pressing and holding down [PWR]

until the display lights and a short signal is heard.

Switch the radio off by pressing and holding down [PWR]

until the display is extinguished and a long signal is heard.

4.3 Volume setting

The sound volume is shown to the lower left of the display.

Several dashes signify a high volume.

Press [▲] to raise and [▼] to lower volume.

4.4 Selecting a channel

The frequency band PMR446 consists of 8 channels num-

bered from 1 to 8. For the radios to communicate with one

another or with other radios all radios must be tuned to the

same channel and subtone.

a. Press [MENU] once. The active channel blinks

on the display.

b. Press [▲] or [▼] to ﬁnd desired channel.

c. Press PTT conﬁrm choice of channel.

4.4.1 Selecting CTCSS subtone

Subtones are used mostly when several users are sharing

the same channel. The receiving radio must be tuned to

the same subtone as the transmitting radio.

You need not choose a subtone, but then you will hear

all the trafﬁc on the channel selected.

a. Press two times on [MENU]. The subtone indicator

blinks on the display.

b. Select any one the 38 subtones with the buttons [▲]

or [▼]. Set subtone: „“00” to switch off function.

c. Press [PTT] to conﬁrm the subtone selection.

4.4.2 Select DCS (digital subtone)

a. Press [MENU] three times.. The current DCS-code

blinks in the display.

b. Press [▲] or [▼] to select one of the 83 DCS-codes.

The digital subcode “00” shuts the function off.

c. Press [PTT] to conﬁrm selection of DCS-code.

4.4.3 Sending and receiving– Don’t forget:

With a communications radio transmission is possible

in only one direction at a time. I.e., you cannot receive

a message while you are talking (called simplex).

PMR446 is a license-exempt frequency band and is shared

by many users. If there are several users on one channel, it

is recommended that you identify yourself at the beginning

and at the end of the conversation.

4.4.4 Transmitting (speaking to someone else)

a. Press [PTT] and hold down. The transmission indicator

(TX) on the display lights up.

b. Hold the radio vertically with the microphone (MIC) circa

5 cm from your mouth. Speak clearly in a normal voice,

without shouting into the microphone. Always wait one-

half second after [PTT] has been pressed before you

begin speaking.

c. Release [PTT] to stop transmitting and listen to the

other user.

– Always wait one-half second after you have stopped

speaking before you release [PTT].

Take care not to press [PTT] while the other user is speaking.

Try not to begin transmitting before the other has stopped

transmitting.

Betyg

Berätta vad du tycker om Exibel FX-122 Walkie-talkie genom att betygsätta den. Vill du dela med dig av dina åsikter om denna produkt eller ställa en fråga? Lämna en kommentar nederst på sidan.

Är du nöjd med Exibel FX-122 Walkie-talkie?
Ja Nej

Bli den första personen som betygsätter denna produkt

0 röster

Delta i konversationen om denna produkt

Här kan du dela vad du tycker om Exibel FX-122 Walkie-talkie. Om du har en fråga, läs först noggrant igenom manualen. Att begära en manual kan göras genom att använda vårt kontaktformulär.

Mer om denna bruksanvisning

Vi förstår att det är trevligt att ha en pappersbruksanvisning för din Exibel FX-122 Walkie-talkie. Du kan alltid ladda ner bruksanvisningen från vår hemsida och skriva ut den själv. Om du vill ha en originalbruksanvisning rekommenderar vi att du kontaktar Exibel. De kanske kan tillhandahålla en originalbruksanvisning. Letar du efter bruksanvisningen för din Exibel FX-122 Walkie-talkie på ett annat språk? Välj ditt föredragna språk på vår hemsida och sök efter modellnumret för att se om vi har det tillgängligt.